Project Sheet Special — Swirly Bird

Swirlybird

Measurements:  

  • Whisper White Thick- 4 ¼” x 11”
  • Peekaboo Peach- 3 5/8” x 2 5/8”
  • Whisper White- 3 ½” x 2 ½” + scraps for flowers
  • Cucumber Crush- approx. 3” x 3 ¼”
  • Cardstock Vellum- 2” x 6”
  • DSP: Pop of Pink- 5 ¼” x 4”                   

Instructions:

  1. Start by scoring your Thick Whisper White card base at 5 ½”.
  2. Distress the edges of the DSP with paper snips or scissors. Drag the edge of the scissors along the edge of your paper to fray and maybe rip it a little. Then attach to card front with snail.
  3. Use the Swirly Scribbles Dies to cut the long wavy lines out of Vellum. Attach that to the center of the DSP card front with snail, only in the middle where the adhesive will be hidden with the next layer.
  4. Use the dies to cut the next piece out of Cucumber Crush cardstock. Use the same cardstock to cut 3 small leaves as well.
  5. Stamp the small flower a few times in Sweet Sugarplum, Flirty Flamingo and Peekaboo Peach. I stamped off on a few to get a lighter flower! Punch flowers using ½” circle punch.
  6. Stamp splatter using Smoky Slate ink and sentiment using Memento ink on whisper white cardstock. Then attach to Peekaboo Peach cardstock piece with snail. Attach to card front with dimensionals.
  7. Glue down the green swirly piece with Tombow. Make a messy nest of silver thread in the corner and attach flowers at different heights with glue dots and dimensionals.
  8. Add a few pearls on flowers and green cardstock.

Leave a Comment

Your email address will not be published. Required fields are marked *

Tammy Fite, StampWithTammy.com

Enter your name and email for news and special subscriber-only offers!








Scroll to Top