CARD: Ornate Thanks

ORNATE THANKS

Measurements

  • Thick White: 8-1/2” x 5-1/2”, scored at 4-1/2” for card base
  • Whisper White: 5” x 3-3/4”; 5” x 2-3/4”
  • Terracotta Tile: 5-1/4” x 4”
  • DSP: 4” x 1-1/2” (at least 4 pieces; I used all the papers on this card, but choose to not use the foiled sides)
  • Ribbon: 7”; 4”

Instructions:          

  1. Cut each of the DSP pieces in half diagonally to form 8 triangles.
  2. With a pencil, mark the center point of long edge of smaller piece of Whisper White cardstock. Apply adhesive to entire piece.
  3. Align one long edge of DSP to center line. Align remaining triangles to both sides of first piece, being sure that entire piece of white cardstock is covered. Turn over and trim excess from back.
  4. Adhere DSP piece to larger piece of Whisper White cardstock and then to Terracotta Tile cardstock. Stamp “THANK YOU” with Terracotta Tile ink.
  5. Adhere 7” Terracotta Tile ribbon along seam, adhering to the back. Tie 4” ribbon around longer piece in a single knot.  Adhere layer to folded card base.
  6. Attach one Gilded Gem to either side of greeting.

Leave a Comment

Your email address will not be published. Required fields are marked *

Tammy Fite, StampWithTammy.com

Enter your name and email for news and special subscriber-only offers!








Scroll to Top